TORQUE MASTER CO., LTD.

AIR CONDITIONERS / DESSICANT BREATHERS

Standard air breathers remove a limited amount of solid particle contamination from the air, but allow water vapour to through.

RMF ' Air conditioners ' (desiccant breathers) are highly effective in removing both solid particles and water vapour from the air.

The RMF ' Air conditions' allows tanks to breathe clean, dry air. The revolutionary Z-R gel granules dry the air before it enters the oil tank. The dry air is then filterd by a 3 micron fibre glass (replaceable) spin-on air filter. The air which enters the oil tank is then clean and dry.

The uptake of moisture can be observed by the change in colour of the indicator granules in the Z-R gel. They turn from ruby red (active) at the beginning to a very light orange at saturation (replace). The Z-R gel granules are completely replaceable, non carcinogenic.

An optional contamination indicator shows when the air filter is in need of replacement.RMF 'Air conditioners' can be to hydraulic drive systems, gearboxes, diesel storage tanks and a wide variety of other uses.

RMF ' Air conditioner' applications can be found in the:
- Steel industry - Paper industry - ement/concrete industry - Petrochemical industry - Aircraft industry - wind energy industry

OFF-LINE FILTERS

RMF Off-line filter units can be applied to every imaginable industrial application where hydraulic or lubrication systems are present. pump-motor unit draws fluid out of the tank, filters it and pumps clean oil back into the system.

Off-line filters can continue to work even when the main system is not in use. Element change can also be done without interfering with the main system. The standard range offers filter units reservoirs with a capacity of up to 11,000 litres.

Choices of electrical or air motors are available to suit all industrial requirements and a large selection of filter elements makes it possible to customize the unit to every specific application. If required pre-filters can fitted to every type.

Units are very simple to install.

Over the years, RMF Systems have developed considerable experience in cleansing hydraulic and lubrication systems, helping to keep them clean and reduce down time. Successful applications can found in the following industries:

 - Steel - Plastic injection moulding - Power generation - Marine  - Pulp ＆ paper - Cement - Flight simulator

BY-PASS FILTERS

The RMF By-pass filter units are especially designed for mobile applications in the hydraulic and /or transmission systems.

In the absence of a pumped system, the oil is drawn from the main system by means of a specially designed and integrated pressure compensated flow control value.

The amount of oil extracted from the main system at any time is insignificant ensuring that it will not affect the working of the main system.

Most commonly used biodegradable oils in the mobile sector are suitable for filtration with PMF filter element.

The By-pass filters can also be equipped with special spin-on water absorbing pre-filters. They can accommodate a range of different filter elements to suit any specific requirement,

Over the years, RMF Systems have developed considerable experience in cleaning hydraulic and transmission systems, helping to keep them clean, extend equipment life and reduce cost of ownership(operating costs).

Successful applications include: